Se Pu. 2024 Mar 08. 42(3): 256-263
Herbicides play an important role in preventing and controlling weeds and harmful plants and are increasingly used in agriculture, forestry, landscaping, and other fields. However, the effective utilization rate of herbicides is only 20%-30%, and most herbicides enter the atmosphere, soil, sediment, and water environments through drift, leaching, and runoff after field application. Herbicide residues in the environment pose potential risks to ecological safety and human health. Therefore, establishing analytical methods to determine herbicide residues in environmental samples is of great importance. In this study, an analytical method based on liquid chromatography-tandem mass spectrometry (LC-MS/MS) in positive electrospray ionization mode (ESI+) was developed for the determination of isoxaflutole, metazachlor, and saflufenacil residues in soil, sediment, and water. The instrumental detection parameters, including electrospray ionization mode, mobile phase, and chromatographic column, were optimized. The mobile phases were methanol (A) and 0.1% formic acid aqueous solution (B). Gradient elution was performed as follows: 0-1.0 min, 60%A; 1.0-2.0 min, 60%A-90%A; 2.0-3.0 min, 90%A; 3.0-4.0 min, 90%A-60%A; 4.0-5.0 min, 60%A. The samples were salted after extraction with acetonitrile and cleaned using a C18 solid-phase extraction column. Different solid-phase extraction columns and leaching conditions were investigated during sample pretreatment. Working curves in the neat solvent and matrix were constructed by plotting the measured peak areas as a function of the concentrations of the analytes in the neat solvent and matrix. Good linearities were found for isoxaflutole, metazachlor, and saflufenacil in the solvent and matrix-matched standards in the range of 0.0005-0.02 mg/L, with r≥0.9961. The matrix effects of the three herbicides in soil, sediment, and water ranged from -10.1% to 16.5%. The limits of detection (LODs, S/N=3) for isoxaflutole, metazachlor, and saflufenacil were 0.05, 0.01, and 0.02 μg/kg, respectively. The limits of quantification (LOQs, S/N=10) for isoxaflutole, metazachlor, and saflufenacil were 0.2, 0.05, and 0.05 μg/kg, respectively. The herbicides were applied to soil, sediment, and water at spiked levels of 0.005, 0.1, and 2.0 mg/kg, respectively. The average recoveries for isoxaflutole, metazachlor, and saflufenacil in soil, sediment, and water were in the ranges of 77.2%-101.9%, 77.9%-105.1%, and 80.8%-107.1%, respectively. The RSDs for isoxaflutole, metazachlor, and saflufenacil were in the ranges of 1.4%-12.8%, 1.2%-7.7%, and 1.5%-11.5%, respectively. The established method was used to analyze actual samples collected from four different sites in Zhejiang Province (Xiaoshan, Taizhou, Dongyang, and Yuhang) and one site in Heilongjiang (Jiamusi). The proposed method is simple, rapid, accurate, stable, and highly practical. It can be used to detect isoxaflutole, metazachlor, and saflufenacil residues in soil, sediment, and water and provides a reference for monitoring the residual pollution and environmental behavior of herbicides.
Keywords: herbicides; liquid chromatography-tandem mass spectrometry (LC-MS/MS); sediment; soil; solid-phase extraction (SPE); water